Table of contents
1 | Your Philips remote control | 3 | ||
2 | Button functions | 4 | ||
|
| 2.1 | General functions | 4 |
|
| 2.2 | Dedicated DVR functions | 6 |
|
| 2.3 | Dedicated DVD functions | 6 |
|
| 2.4 | Dedicated SAT functions | 6 |
| 3 | Getting started | 7 | |
|
| 3.1 | Battery installation | 7 |
|
| 3.2 | Code setup | 7 |
|
| 3.3 | Programming combo devices | 8 |
|
| 3.4 | Copy Volume / Mute buttons from another device | 8 |
| 4 | Using the remote control | 9 | |
|
| 4.1 | Controlling devices requiring separate |
|
|
|
| Power On / Off buttons | 9 |
|
| 4.2 | Controlling combo devices | 9 |
| 5 | Keep updated for future devices | 10 | |
|
| 5.1 | Learning commands | 10 |
|
| 5.2 | Clearing commands | 11 |
|
| 5.3 | Tips on learning | 11 |
| 6 | Troubleshooting | 12 | |
7 | Limited Lifetime Warranty | 13 | ||
Notes
•The remote control powers on in TV mode.
•Codes are stored in the permanent remote control memory so you will not lose any codes stored while you are changing batteries
•The remote control automatically turns off if buttons are pressed for more than 30 seconds.This will save your batteries in case the remote control gets stuck in a place where the buttons remain pressed (e.g.,between the sofa cushions).
•Some buttons on the remote control might have functions that are referred to by different names on the device you are controlling. E.g. PREV. CH may be called RECALL or DISPLAY.These differences depend on the brand and model of your device. Also, this remote control can only operate features that exist on your device. E.g., your device must have PREV. CHAN ability for the PREV. CH button to operate this feature.
•The RECORD (0) button must be pressed twice to record. For some brands of DVRs, you might need to press the RECORD (0) once, then press it again for three seconds.
2EN
129238_SRU5107_Short.indd 2 |
