Connections
AC cord connection (see page 12)
– AC cord fixing
Close
1 |
|
| Push until |
| the hook |
1 Plug the AC cord into | clicks. |
| |
the display unit. | Open |
Plug the AC cord until | |
it clicks. | 2. Pull off. |
22 Fix the AC cord with
Note: | the clamper which is | 1. Keep the |
attached to the unit. | knob | |
Make sure that the AC cord is locked | pressed. | |
on both the left and right sides. |
|
|
–Cable fixing bands
Secure any excess cables with bands as required.
Unplug the AC cord
Unplug theAC cord pressing the two knobs.
Note:
When disconnecting the AC cord, be absolutely sure to disconnect the AC cord plug at the socket outlet first.
Pass the attached cable fixing band through the clip as shown in the figure.
To secure cables connected to Terminals, wrap the cable fixing band around them then pass the pointed end through the locking block, as shown in the figure.
While ensuring there is sufficient slack in cables to minimize stress (especially in the power cord), firmly bind all cables with the supplied fixing band.
1
2
To tighten: | To loosen: |
| Push the catch |
Pull |
|
Pull 
AUDIO
SLOT1 | SLOT2 | SLOT3 | PC IN |
SERIAL
Optional Terminal Board Insert Slot (covered)
From EXTERNAL monitor terminal on Computer (see page 10)
From SERIAL Terminal on Computer (see page 11)
9
