PHL Audio 5100 15 Bass Driver

Ø 380.5 max.

Ø 354.5 max.

Ø 406.5 max

(on angles)

Red dot

155.5 max. 2 x screw button

terminals

8 x Ø 6.5 Holes eq. spaced

on Ø 388 and on Ø 370

Ø 204 max.

5100

TYPICAL CHARACTERISTICS

Rated impedance Z 8 Ω

Reference efficiency (1 W@1 m) - 98 dB SPL

Usable frequency range 1- 40–1500 Hz

Power handling capacity 2(AES) - 400 W

Max Sound Pressure Level 3SPLmax 120 dB SPL

Min. impedance modulus Zmin 6.5 @ 220Hz Ω

Voice-coil inductance 4@ 1 kHz Le1k 1.41 mH

@ 10 kHz Le10k 0.58 mH

Bl product Bl 20.8 N/A

Moving mass Mms 0.102 Kg

THIELE-SMALL PARAMETERS: TYPICAL (QC LIMITS)

Resonance frequency 5Fs39 (±5) Hz

DCresistance 6Re5.6 (±0.5) Ω

Mechanical quality factor Qms 4.2 1

Electrical quality factor Qes 0.32 1

Total quality factor Qts 0.30 1

Mechanical suspension compliance Cms 160 10-6m/N

Effective piston area Sd0.0892 m2

Equivalent Casair load Vas 0.180 m3

Max.linear excursion Xmax ±7.0 mm

Linear displacement volume Vd0.624 10-3m3

Half-space efficiency 3.2 %

Unity load volume Vas Qts216.4 10-3m3

ABSOLUTE MAXIMUM RATINGS

Short term max. input voltage 7Vmax 125 V

Max. excursion before damage Xdam 14 mm

Ambient operating temperature –10 to +50 °C

Storage temperature 8–20 to +70 °C

Environmental conditions 9Outdoor

APPLICATION INFORMATION

Air volume occupied by the driver 10 4.3 10-3 m3

Speaker net mass 9.1 Kg

Recommended reflex box Vb/Fb65 / 55 L / Hz

Electrical polarity A positive voltage applied on the red

terminal produces forward cone motion.

PHYSICAL CHARACTERISTICS

PHL Audio S.A. provides these specifications as representative of current production after conditioning. Because of our continuous research, they are subject to change without notice.

SPECIFICATION NOTES

Note 1: Allowing for energy response, excursion

capability, Power spectrum, and -3dB low

freq. roll-off for standard reflex tuning.

Note 2: Established at 20°C ambient temp, according to

AES2-1984 standard using IEC268-1 simulated

programme signal and a 75 liter Bass-Reflex test

enclosure tuned at 45Hz.

Note 3: Established at 1m on axis of the loudspeaker mounted

in test enclosure, when driven at full AES Power

Handling Capacity, including 4dB of thermal

compression loss.

Note 4: Measured at 20 mA in free air.

Note 5: Measured at 20 mA and 20°C ambient temp.

in free air conditions, after full run and rest.

Note 6: Measured at 20°C ambient temp.

QC limits are ±10%

Note 7: Stated in RMS voltage according to IEC 268-5.

Note 8: Includes shipping conditions. The lower limit prevents

from demagnetization.

Note 9: Our products are classified in three categories :

Indoor, Outdoor, and Outdoor

✚

for permanent

outdoor use or severe conditions.

Note 10: Calculated for front mounting on to a 18 mm thick

board.

461, rue des chênes ■Z.A

77590 CHARTRETTES

FRANCE

Tél : 33 01 64 81 29 80

Fax :33 01 60 69 10 28

e-mail : phlaudio@phlaudio.com

http: //www.phlaudio.com

5100

15” Bass Driver