Subwoofer Owner’s Manual
LED WIRING
SMALL TERMINAL: LEDs
(+12v and Ground Only)
The Elite.12 has three terminals. The two larger terminals are connected to the voice coils. The small terminal is used to power the LEDs with a +12v and ground connection only.
DO NOT CONNECT AN AMPLIFIER’S SPEAKER OUTPUT TO THE LED TERMINAL. It will damage the LEDs, this is not covered by warranty. Only use +12v and ground to power the LEDs.
LARGE TERMINAL:
VOICE COIL
SPECIFICATIONS
T/S Parameters: | Elite.12d4 | Elite.12d2 |
|
|
|
Re (Dcr) | 1.7 | 1.0 |
FS (Hz) | 31 | 30 |
Sd (SqM) | .05 | .05 |
|
|
|
BL TM | 14.4 | 12.2 |
Qms | 3.23 | 3.5 |
Qes | .49 | .57 |
|
|
|
Qts | .42 | .49 |
Vas (liters) | 31.1 | 20.5 |
Cms (uM/N) | 85 | 60 |
|
|
|
Mms (gms) | 300 | 428 |
Impedance | Dual 4 | Dual 2 |
FEATURES:
•60mm of Peak to Peak Excursion
•Dual 4 and 2 Ohms Voice Coils
•3.0” Premium OFC Copper Wound Voice Coil
•Dual Long Throw Spider Suspension
•Woven Tinsel Leads
•Composite Material Hybrid Cone
•High Excursion CAE/CAD Motor Design
•Vented
•One Piece Aluminum Plated Dustcap with
•High Roll Butyl Rubber Surround
•Nickel Plated 12 Gauge Speaker Terminal
•Optimized for Sealed or Vented Enclosures
•Rigid Powder Coated
*Specifications subject to change
**Parameters are AFTER break in. Elite.12 does not require any special break in procedure. One to two weeks of normal use will naturally break in the suspension of the driver.
Specifications: |
| Elite.12d4/2 |
|
|
|
RMS Power Handling |
| 1600 watts |
Xmax (Peak to Peak) |
| 60mm |
Mounting Diameter | 11 | 5/16in - 287mm |
|
|
|
Mounting Depth | 7 | 1/8in - 180mm |
Power Handling Note:
The Elite.12’s recommended power range is 1200 to 1600 watts RMS for normal use. Driving the woofer with significantly higher RMS power will cause thermal failures (burnt voice coils) and will have no audible increase in output. A subsonic filter is also required when using a vented enclosure as it will increase reliability and perfomance drastically.
www.phoenixgold.com
