With the AST 220S and the AST-Stand lying flat, attach the two wires together, noting that the slide-on connectors are sized differently to maintain proper phase in the connection. Now, carefully slide the metal support into the channel on the rear of the AST 220S. Align the four brass pins extending from the top of the AST-Stand with the four channels on the inside of the AST 220S, and slide the two units together so that they fit tightly against the plastic spacer of the AST-Stand.

Now insert and tighten the two remaining screws attaching the metal support to the AST 220S.

You may now connect the speaker cable to the terminals at the bottom of the AST 220S / Stand combination.

Connecting the Speaker cable to the AST 220 speakers

Strip away 1/2 inch of the insulation on the Speaker wire and tightly twist the strands of each conductor together. If a soldering iron is available carefuly tin the two conductors of each speaker cable.

Next, bend the exposed portion of the speaker cable to a 90º angle to the insulation.

Press down the top of the terminal and insert the speaker cable into the hole at the bottom of the connector in the direction of the closest end of the connector cup.

Always be careful to observe

proper polarity, making sure to connect (+) to (+) and

connect (-) to (-). Failure to do so will cause a loss of low frequency response and improper imaging.

Specifications

AST 220S Home Theater Satellite

•Plasma application "slim" wall mount design loudspeaker system

•Height 20” overall

•Dual 4.25” mid/woofers and poly treated silk dome tweeter

•Sensitivity: 89 dB/ @ 2.83V / 1m

•Impedance: 8 Ohm nominal

•Frequency Response: +/- 2.5 dB from 90-20 kHz (-6 dB @ 72 Hz.)

•Recommended safe amplifier power: 15 - 200 watts

RMS

•CAD/CAE designed High order, Asymmetrical, Phase compensating, acoustical passive crossover

•3.5” (90mm) D x 5.25” (133mm) W x 20.25” (514mm)H

AST 220C Home Theater Center Channel

•Plasma application "slim" wall mount design loudspeaker system.

•Length 20” overall

•Dual 4.25” mid/woofers and poly treated silk dome tweeter

•Sensitivity: 89 dB/ @ 2.83V / 1m

•Impedance: 8 Ohm nominal

•Frequency Response: +/- 2.5 dB from 90-20 kHz (-6 dB @ 72 Hz.)

•Recommended safe amplifier power: 15 - 200 watts

RMS

•CAD/CAE designed High order, Asymmetrical, Phase compensating, acoustical passive crossover

•3.5” (90mm) D x 5.25” (133mm) W x 20.25” (514mm)H

AST Stand Home Theater Floor Stand

•Home Theater application "Floor Stand” for AST 220S

•Height 47” overall

•Matching Aluminum Extrusion

•Floor Level Speaker Level Input

•3.5” D x 5.25” W x 27” H

4