Phoenix Gold TI269PS Crossover Wiring, Installation, To Amplifier or Headunit, To Tweeter

Ti2 Pointsource Owner’s Manual

CROSSOVER WIRING

To Amplifier or Headunit

+

-

TI2

POINTSOURCE

CROSSOVER

To Tweeter To Woofer

T+ T- W+ W-

INSTALLATION:

-The provided external passive crossovers MUST be used with the Ti2 Pointsource speakers. Speaker damage WILL occur if the external crossovers are not used.

-Installation is simple just follow the clearly marked labels on the wiring and speaker terminals. The wiring connections are also marked on the internal PCB which is accessible by removing the crossover housing’s top cover.

-Each speaker has two seperate (and clearly labeled) terminals: one for the tweeter and one for the woofer. Both terminals must be used and connected to the correct wires on the passive crossover.

-IMPORTANT: USE THE PRE-TERMINATED SPADE TERMINALS FOR EASY INSTALLATION. DO NOT CUT THEM OFF!

The crossover wires are pre-terminated with the correct size spade terminals that match the correct size terminal on the speaker. This makes installation much faster/easier, and also makes it impossible to mistakenly wire the woofer wires from the crossover to the tweeter terminal on the speaker.

-Double check all the wiring connections before turning the system on. Most importantly double check the woofer wires from the crossover are NOT wired to the tweeter terminal of the speaker. The tweeter will be damaged if this occurs.

www.phoenixgold.com