Amplifier Owner’s Manual
SPECIFICATIONS
Ti2 800.1 SPECIFICATIONS
Frequency Response: | ± 1dB from 20Hz to 200Hz | RMS Power Output | 600w x 1 @ 2 ohms |
Signal to Noise Ratio: | >90dB |
| 800w x 1 @ 1 ohm |
Low Pass Crossover: | 24dB per Octave | Power/Ground Wire Size: | 4 Gauge |
Subsonic Filter: | 48dB per Octave | ||
Low Pass Crossover Range: | 30Hz to 200Hz | Recommend Power Wire Fuse: | 80a |
Subsonic Crossover Range: | 10Hz to 55Hz | Dimensions (Includes Feet): | 11.7” L x 7.1”W x 2.0” H |
Bass Boost @ 45Hz: | 0 to +18dB |
| 296mm L x 180mm W x 52mm H |
Low Level Input Range: | 200 millivolts to 8 volts |
|
|
Lowest Recommend Load: | 1 ohm |
|
|
Typical Efficiency: | 80% |
|
|
Damping Factor: | Greater than 200 |
|
|
Variable Phase Adjustment: | 0 to 180 Degrees |
|
|
Ti2 1300.1 SPECIFICATIONS
Frequency Response: | ± 1dB from 20Hz to 200Hz | RMS Power Output | 900w x 1 @ 2 ohms |
Signal to Noise Ratio: | >90dB |
| 1300w x 1 @ 1 ohm |
Low Pass Crossover: | 24dB per Octave | Power/Ground Wire Size: | 4 Gauge |
Subsonic Filter: | 48dB per Octave | ||
Low Pass Crossover Range: | 30Hz to 200Hz | Recommend Power Wire Fuse: | 100a |
Subsonic Crossover Range: | 10Hz to 55Hz | Dimensions (Includes Feet): | 14.4” L x 7.1”W x 2.0” H |
Bass Boost @ 45Hz: | 0 to +18dB |
| 366mm L x 180mm W x 52mm H |
Low Level Input Range: | 200 millivolts to 8 volts |
|
|
Lowest Recommend Load: | 1 ohm |
|
|
Typical Efficiency: | 80% |
|
|
Damping Factor: | Greater than 200 |
|
|
Variable Phase Adjustment: | 0 to 180 Degrees |
|
|
IMPORTANT: A power birth certificate is included for each amplifier. Ti2 amplifiers are conservatively rated and will exceed their RMS power rating shown here. All RMS power ratings and measurements are at 14.4 volts with no more than 1% THD.
Phoenix Gold • www.phoenixgold.com