Pico Macom TA-52 operation manual F E A T U R E S, Front Panel

F E A T U R E S

Front Panel

1

2

3

4

5

6

7

LO BAND

u•

™

-10DB

IN

pec ®

FM TRAP

0DB

OUT

GAIN

TILT

UHF/VHF/FM

VHF/FM

DISTRIBUTION AMPLIFIER

SEPARATE

-10DB

HI BAND

MODEL TA-52

CAUTION

ATTENUATOR

DO NOT REMOVE SCREWS

COMBINED

0DB

GAIN

TILT

INPUT

UHF/VHF OUTPUT

117V

-10DB

UHF

PL

1A

ON

40W

ATTENUATOR

FUSE

GAIN

MONITOR-20DB

UHF OR

0DB

COMBINED

8

9

10 11

12

13 14

15

16

17

18

1.	UHF or Combined: Connect UHF or	10.	Gain Adjust:
	UHF/VHF antenna to this port.		Potentiometer provides for R.F. hi-band gain adjustment
2.	VHF/FM:	11.	Gain Adjust:
	Connect VHF antenna to this port		Potentiometer provides for R.F. uhf-band gain adjustment
3.	Separate or Combined:	12.	Tilt:
	If using separate VHF and UHF antennas, position		Potentiometer provides for hi-band slope adjustment
	slide switch on "Separate". If using UHF/VHF broad-
	band antenna, position slide switch on "Combined"	13.	UHF/VHF Output:
			Connect this port to distribution system

4.-10 dB:

Provides 10 dB attenuation to low-band input. 14. Monitor -20 dB:

Used to monitor output signal

5.FM Trap:

Provides blocking of FM signal if required. 15. Power LED:

Indicates when amplifier is on.

6.Gain Adjust:

Potentiometer provides for R.F. low-band gain adjustment

7.Tilt:

Potentiometer provides for low-band slope adjustment

8.-10 dB:

Provides 10 dB attenuation to hi-band input.

16.Fuse:

Replace with 1 amp 250 volt fuse.

17.On/Off:

Power on or off switch

18.Power Cable:

The three prong type power plug connects to a 120 Vac, 60 Hz electrical outlet.

9.-10 dB:

Provides 10 dB attenuation to uhf-band input.

4

PICO MACOM INC. 12500 Foothill Blvd. • Lakeview Terrace, CA 91342 • (818) 897-0028 (800) 421-6511 • FAX (818) 834-7197