Pinnacle Speakers 3, 5

• Simply connect your subwoofer, using either the L or R Line Input jack, to the subwoofer output jack on

your receiver.

• If you have a Dolby Digital (AC -3) or DTS receiver or processor place the subwoofer's Crossover

Bypass switch in the ON position (this bypasses the Low Pass Filter in the subwoofer).

• If you do not have a Dolby Digital (AC-3 ) or DTS receiver or processor place the subwoofer's Crossover

Bypass switch in the OFF position (this activates the Low Pass Filter in the subwoofer).

• If your receiver or processor has no subwoofer output jack you can connect your subwoofer, using its L

& R input jacks, to your receiver or processor's pre-amp left & right channel outputs. If your receiver or

processor uses jumpers to connect its pre-amp outputs with its inputs you will need to acquire two

splitter cables (Radio Shack #42- 2435) to be able to hookup your sub while continuing to provide a signal

to your receiver or processor's inputs.

• Lastly, wire your left and right front speakers directly to your receiver’s speaker outputs. Please refer to

the Option #1 wiring diagram for further clarification.

OPTION #2 -Using The Binding Post Inputs: