4)Orient the bracket so that it is level. Mark on the wall the locations for the bracket’s mounting screws. Remove the mounting bracket from the wall.
5)Drill 2" deep pilot holes at each of the mounting screwhole marks on the wall using the 1/8" bit if mounting into a stud, or the 1/4" bit (and then inserting the included wall anchors) where there is no stud.
6)Place the bracket back on the wall lining up the screw holes of the bracket with the holes on the wall. Be sure to orient the bracket with the appropriate keyhole slots pointing down. Screw the included mounting screws fully into the pilot holes or wall anchors. The bracket should now be securely attached to the wall.
7)Attach your speaker wires to the speaker, being sure to observe proper polarity (amplifier speaker output positive (+) to the red terminal, amplifier speaker output negative
8)Position the cabinet so that the rear groove (A) is on the right rear for Vertical Mounting or at the top rear for Horizontal Mounting.
VERTICAL MOUNTING
HORIZONTAL MOUNTING