Installing the Pioneer

Connecting the Electrical Components:

Plug the hand control into the vehicle wiring harness. Then plug the other end into the electrical harness located on the rear of the lift.

Extending the Lift: Push the down button

on the hand control to extend the lift in the

horizontal direction.

Hand Control

Vehicle Wiring Harness

Lift

CAUTION: Watch the lift as it extends. Make sure the moving components of the lift do not rub against the vehicle’s interior, door lip, or door latch. You may need to stop and adjust the lifts height, by repeating the steps on the installation page.

When the lift is fully extended, it will start to run down in the vertical direction. At this point stop the lift. If you are using the Pioneer to lift power chairs the platform is now ready to be installed. If you are using the Pioneer to transport scooters, follow the instructions on the Page 8 for how to modify the platform for use with a Scooter.

Installing the Platform for use with a

Power Chair:

Bolt the platform to the lift assembly as shown to the right using the supplied 1/2” diameter and 5/16” diameter

hex bolts.

Page 6
Image 6
Pioneer AL600 owner manual Installing the Pioneer, Connecting the Electrical Components