Section

 

03

Installation

Installation

j When using a subwoofer of 70 W (2 W), be

! Consult your dealer if installation requires

sure to connect the subwoofer to the violet

drilling of holes or other modifications to the

and violet/black leads of this unit. Do not

vehicle.

connect anything to the green and green/

! Do not install this unit where:

black leads.

— it may interfere with operation of the vehicle.

k Not used.

— it may cause injury to a passenger as a result

l Subwoofer (4 W)× 2

of a sudden stop.

Notes

! The semiconductor laser will be damaged if

it overheats. Install this unit away from hot

! With a 2 speaker system, do not connect any-

places such as near the heater outlet.

thing to the speaker leads that are not con-

! Optimum performance is obtained when the

nected to speakers.

unit is installed at an angle of less than 60°.

! Change the initial menu of this unit. Refer to

 

SP-P/O MODE (rear output and preout set-

60°

ting) on page 8.

The subwoofer output of this unit is monau-

 

ral.

 

DIN Front-mount

1 Insert the mounting sleeve into the dash- board.

For installation in shallow spaces, use the supplied mounting sleeve. If there is enough space, use the mounting sleeve that came with the ve- hicle.

2 Secure the mounting sleeve by using a screwdriver to bend the metal tabs (90°) into place.

1

2 Tighten two screws on each side.

1

3

 

2

1Screw

2Mounting bracket

3Dashboard or console

!Use either truss (5 mm × 8 mm) or flush sur- face (5 mm × 9 mm) screws, depending on the bracket screw holes.

Removing the unit

Power amp (sold separately)

Perform these connections when using the optional amplifier.

13

 

2

 

4

 

5

 

5

 

1 System remote control Connect to Blue/white cable.

2 Power amp (sold separately)

3 Connect with RCA cables (sold separately)

4 To Rear output or subwoofer output

5 Rear speaker or subwoofer

!When installing, to ensure proper heat dis- persal when using this unit, make sure you leave ample space behind the rear panel and wrap any loose cables so they are not block- ing the vents.

Leave ample

space

5 cm

5 cm

5cm

2

1Dashboard

2Mounting sleeve

#Make sure that the unit is installed securely in place. An unstable installation may cause skipping or other malfunctions.

DIN Rear-mount

1Determine the appropriate position where the holes on the bracket and the side of the unit match.

1 Remove the trim ring.

1Trim ring

2Notched tab

!Releasing the front panel allows easier ac- cess to the trim ring.

!When reattaching the trim ring, point the side with the notched tab down.

Installation

Important

!Check all connections and systems before final installation.

!Do not use unauthorized parts as this may cause malfunctions.

DIN front/rear mount

This unit can be properly installed using either front-mount or rear-mount installation.

Use commercially available parts when instal- ling.

2Insert the supplied extraction keys into both sides of the unit until they click into place.

10En