Section

03 Installation

 

Section

Installation

03

Power amp (sold separately)

Perform these connections when using the optional amplifier.

13

 

2

 

4

 

5

 

5

 

 

 

3

1

2

 

 

6

 

7

 

7

 

1System remote control Connect to Blue/white cable.

2Power amp (sold separately)

3Connect with RCA cables (sold separately)

4To Rear output or subwoofer output

5Rear speaker or subwoofer

6To Front output

7Front speaker

Installation

Important

! Check all connections and systems before final installation.

!Optimum performance is obtained when the unit is installed at an angle of less than 60°.

60°

DIN front/rear mount

This unit can be properly installed using either front-mount or rear-mount installation.

Use commercially available parts when instal- ling.

DIN Front-mount

1 Insert the mounting sleeve into the dashboard.

For installation in shallow spaces, use the supplied mounting sleeve. If there is enough space, use the mounting sleeve that came with the vehicle.

2 Secure the mounting sleeve by using a screwdriver to bend the metal tabs (90°) into place.

1

3Install the unit as illustrated. 1

2

3

4

5

1Nut

2Firewall or metal support

3Metal strap

4Screw

5Screw (M4 × 8)

#Make sure that the unit is installed securely in place. An unstable installation may cause skip- ping or other malfunctions.

DIN Rear-mount

1Determine the appropriate position where the holes on the bracket and the side of the unit match.

Removing the unit

1 Remove the trim ring.

1Trim ring

2Notched tab

!Releasing the front panel allows easier ac- cess to the trim ring.

!When reattaching the trim ring, point the side with the notched tab down.

2Insert the supplied extraction keys into both sides of the unit until they click into place.

3Pull the unit out of the dashboard.

English

! Do not use unauthorized parts as this may cause malfunctions.

! Consult your dealer if installation requires drilling of holes or other modifications to the vehi- cle.

! Do not install this unit where:

— it may interfere with operation of the vehi- cle.

— it may cause injury to a passenger as a result of a sudden stop.

! The semiconductor laser will be damaged if it overheats. Install this unit away from hot places such as near the heater outlet.

2

1Dashboard

2Mounting sleeve

2Tighten two screws on each side.

1 3

2

1Screw

2Mounting bracket

3Dashboard or console

!Use either truss (5 mm × 8 mm) or flush surface (5 mm × 9 mm) screws, depending on the bracket screw holes.

Removing and re-attaching the front panel

You can remove the front panel to protect your unit from theft.

For details, refer to Removing the front panel to protect your unit from theft and Re-attaching the front panel on page 5.

Fastening the front panel

If you do not plan to detach the front panel, the front panel can be fastened with supplied screws and holders.

16

En

En

17