Installation
Installation | Use commercially available parts when instal- | |
Important | ling. | |
| ||
! Check all connections and systems before | DIN | |
final installation. | ||
| ||
! Do not use unauthorized parts as this may | 1 Insert the mounting sleeve into the dash- | |
cause malfunctions. | board. | |
! Consult your dealer if installation requires | For installation in shallow spaces, use the sup- | |
drilling of holes or other modifications to the | plied mounting sleeve. If there is enough space, |
|
| Section |
Installation |
| 04 |
2 Tighten two screws on each side. | 3 Pull the unit out of the dashboard. | |
1 | 3 | English |
|
| |
2 |
|
|
vehicle. | use the mounting sleeve that came with the ve- |
! Do not install this unit where: | hicle. |
—it may interfere with operation of the vehicle.
— it may cause injury to a passenger as a result | 2 Secure the mounting sleeve by using a | |
of a sudden stop. | screwdriver to bend the metal tabs (90°) into | |
! The semiconductor laser will be damaged if | place. | |
it overheats. Install this unit away from hot | 1 | |
places such as near the heater outlet. | ||
! Optimum performance is obtained when the |
| |
unit is installed at an angle of less than 60°. |
| |
60° |
| |
| 2 | |
! When installing, to ensure proper heat dis- | 1 Dashboard | |
2 Mounting sleeve | ||
persal when using this unit, make sure you | ||
# Make sure that the unit is installed securely in | ||
leave ample space behind the rear panel and | ||
place. An unstable installation may cause skipping | ||
wrap any loose cables so they are not block- | ||
or other malfunctions. | ||
ing the vents. | ||
| ||
| DIN |
1Screw
2Mounting bracket
3Dashboard or console
!Use either truss (5 mm × 8 mm) or flush sur- face (5 mm × 9 mm) screws, depending on the bracket screw holes.
Removing the unit
1 Remove the trim ring.
1Trim ring
2Notched tab
!Releasing the front panel allows easier ac- cess to the trim ring.
!When reattaching the trim ring, point the side with the notched tab down.
Removing and
You can remove the front panel to protect your unit from theft.
For details, refer to Removing the front panel and
Securing the front panel
The front panel can be secured with the supplied screw.
1
1Screw
Installing the microphone
Only for
|
| 1 Determine the appropriate position | |
Leave ample | 5 cm | where the holes on the bracket and the side | |
space | of the unit match. | ||
| |||
| 5 cm | 5cm |
DIN front/rear mount
This unit can be properly installed using either
2Insert the supplied extraction keys into both sides of the unit until they click into place.
CAUTION
It is extremely dangerous to allow the microphone lead to become wound around the steering column or shift lever. Be sure to install the unit in such a way that it will not obstruct driv- ing.
Notes
!Install the microphone in a position and ori- entation that will enable it to pick up the voice of the person operating the system.
En 21