Additional information
09
46
En
No audio, or audio is
distorted.
• No audio is output during slow motion playback or when scanning
discs other than audio CDs.
• Some DVD discs do not output digital audio: Switch your amplifier
to the player's analog outputs.
• Check that the disc is free from dust and dirt, and that it is not
damaged (page 42).
• Check that all interconnects are firmly inserted.
• Check that the plugs and terminals are free of dirt, oxide, etc. and
clean if necessary. Also check the cable for damage.
• Make sure the player's output is not connected to the amplifier's
phono (turntable) inputs.
• Check your amplifier/receiver’s settings (volume, input function,
speaker settings, etc.).
The analog audio is OK,
but there appears to be
no digital audio signal.
• Make sure that the
Digital Out
setting is set to
On
(page 35).
• Check that the Dolby Digital, DTS and MPEG out settings (page 35)
are suitable for your amplifier/receiver—check the instruction manual
that came with your amplifier/receiver.
Noticeable difference in
DVD and CD volume.
• This is due to differences in the audio format and is not a
malfunction.
Cannot play multi-
channel audio.
• Check that the Dolby Digital, DTS and MPEG Out settings (page 35)
are suitable for your amplifier/receiver—check the instruction manual
that came with your amplifier/receiver.
• Check the audio options available from the disc menu.
Cannot listen to high-
sampling rate audio
through the digital
output.
• Make sure that
96 kHz PCM Out
is set to
96 kHz
.
• As a copy-protection measure, some DVDs do not output 96kHz
audio. In this case, even if set to
96 kHz
, the player automatically
outputs the audio at 48 kHz. This is not a malfunction.
Cannot output 96kHz or
88.2kHz digital audio.
• Check that
96 kHz PCM Out
is set to
96 kHz
.
• Some discs are digital copy protected and do not output high
sampling rate digital audio. In this case the output is automatically
downsampled.
No DTS audio output.
• If this unit is connected to a non-DTS compatible amplifier or
decoder using a digital audio cable, set
DTS Out
to
DTS
>
PCM
(page 35). If you do not do this, noise will be output when you play a
DTS disc.
• If this unit is connected to a DTS-compatible amplifier or decoder
using a digital audio cable, check the amplifier settings, and that the
cable is properly connected.
Can’t hear effect of
Virtual Surround.
• The effectiveness of Virtual Surround varies with the disc.
Problem Remedy
DV400V_KUC_EN.book 46 ページ ２００７年３月１４日　水曜日　午後８時８分