Connecting Up02
12
En
•Before unplugging the player from the
power outlet, make sure you first switch
it into standby using either the front
panel STANDBY/ON button, or the
remote control, and wait of the -OFF-
message to disappear from the player’s
display.
•For the above reasons, do not plug this
player into a switched power supply
found on some amplifiers and AV
receivers.
Connecting using the S-Videooutput
If your TV has an S-Video input, you can use
this instead of the standard (composite)
output for a better quality picture.
1 Use an S-Video cable (not supplied)
to connect the S-VIDEO OUT to an
S-Video input on your TV (or monitor or
AV receiver).
Line up the small triangle above the jack
with the same mark on the plug before
plugging in.
DIGITAL AUDIO OUT
S
L
R
VIDEO OUT
COAXIAL
OPTICAL
AUDIO OUT
AV CONNECTOR (RGB)-TV
TV
S-VIDEO
INPUT
Connecting using the AVconnector output
If your TV has a SCART-type AV input, you
can use a SCART cable to connect this
player to your TV. This type of connection
carries both the sound and the picture, so
there’s no need to connect up the AUDIO
OUT L/R and VIDEO OUT jacks.
1 Use a SCART cable (not supplied) to
connect the AV CONNECTOR (RGB)-TV to
an AV input on your TV.
DIGITAL AUDIO OUT
S
L
R
VIDEO OUT
COAXIAL
OPTICAL
AUDIO OUT
AV CONNECTOR (RGB)-TV
TV
SCART
This connector can output standard (com-
posite), S-Video or RGB component video.
The default setting is standard, which should
work with all TVs. Consult the manual that
came with your TV to see if you can use one
of the higher quality settings. See page 41
for how to change the video output.
•SCART cables are available in several
configurations. Make sure that the one
you get will work with this player and
your TV/monitor. You can find the pin
assignments on page 54.