DVD-114 Operating Instructions

7)Device Configuration Jumper

set this jumper switch to select the drive use mode supporting the computer (jumpered = ON; no jumper = OFF)

Pin

Name

Function

 

 

 

 

1

MA*1

on

Drive set to Master mode

2

SL

on

Drive set to Slave mode

 

 

 

 

3

CS

on

Drive set to Cable Select mode

 

 

 

 

4

 

Reserved

5

RPC

on

Stays in RPC Phase I mode

 

SET

 

 

 

off

Starts in PRC Phase II mode

 

*1 *2

 

 

never return to Phase I mode

 

 

 

 

 

 

after using Phase II mode

 

 

 

 

8)Host IDE Interface

40-pin I/O connector in accordance with ATA specifications

9)DC Input

power supply input for DC +5 V and +12 V

Pin

Name

Function

 

 

 

1

+12

Power supply input for DC +12 V

 

 

 

2

G

Ground

 

 

 

3

G

Ground

 

 

 

4

+5

Power supply input for DC +5 V

 

 

 

4.3Region Code Information

The maximum number of times the Region Code may be changed is five (5), including the initial setting. The fifth change becomes PERMANENT.

Note: Region Codes are part of the DVD Standard, however, Region Codes on DVD discs are optional. DVD discs with no specified Region Code may be played on any player.

5.0INSTALLATION

The following information provides step-by-step instructions to install the DVD-103S.

5.1Positioning the Drive

Before beginning the installation, decide if the drive needs to be positioned horizontally (standard) or vertically. Review all instructions prior to install the DVD-114 drive.

- 7 -