Section

Operating this unit

01

!Adjusted equalizer curve settings are stored in

CUSTOM.

1Press M.C. to display the setting mode.

2Press M.C. to select BASS (bass)/MID (mid)/TRE- BLE (treble).

3Turn M.C. to adjust the level. Adjustment range: +6 to -6

LOUDNESS (loudness)

Loudness compensates for deficiencies in the low- and high-frequency ranges at low volume.

1Press M.C. to display the setting mode.

2Turn M.C. to select the desired setting. OFF (off)—LOW(low)—HIGH (high)

3Press M.C. to confirm the selection.

SLA (source level adjustment)

SLA (Source Level Adjustment) lets you adjust the volume level of each source to prevent radical changes in volume when switching between sources.

!When selecting FM as the source, you cannot switch to SLA.

!Settings are based on the FM volume level, which remains unchanged.

!The AM volume level can also be adjusted with this function.

1Press M.C. to display the setting mode.

2Turn M.C. to adjust the source volume. Adjustment range: +4 to –4

3Press M.C. to confirm the selection.

Activate this setting when using an auxiliary device connected to this unit.

1Press M.C. to turn AUX on or off.

USB (plug and play)

This setting allows you to switch your source to USB automatically.

1Press M.C. to turn the plug and play on or off. ON – When USB storage device is connected, the source is automatically switched to USB. If you disconnect your USB storage device, this unit’s source is turned off.

OFF – When USB storage device is connected, the source is not switched to USB automatically. Please change the source to USB manually.

Using an AUX source

1Insert the stereo mini plug into the AUX input jack.

2Press SRC/OFF to select AUX as the

source.

# AUX cannot be selected unless the auxiliary

setting is turned on. For more details, refer to AUX (auxiliary input) on this page.

English

Initial Settings

1Press SRC/OFF and hold until the unit turns off.

2Press M.C. and hold until CLOCK SET ap- pears in the display.

3Turn M.C. to select the initial setting. After selecting, perform the following proce- dures to set the initial setting.

CLOCK SET (setting the clock)

1Press M.C. to display the setting mode.

2Press M.C. to select the segment of the clock dis- play you wish to set.

Hour—Minute

3Turn M.C. to adjust the clock.

AUX (auxiliary input)

Displaying the clock

%Press CLOCK to turn the clock display

on or off.

# The clock display disappears temporarily

when you perform other operations, but the clock display appears again after 25 seconds.

En 9