Connecting the units

!Install and route the separately sold battery wire as far as possible from the speaker wires. Install and route the separately sold battery wire, ground wire, speaker wires and the am-

plifier as far away as possible from the anten- na, antenna cable and tuner.

About bridged mode

Speaker impedance is max. 4 W, please carefully check. Improper connection to the amplifier may result in malfunction or personal injury due to burns from overheating.

For bridged mode for a two-channel amplifier, with a 4 W load, either wire two 8 W speakers in parallel, Left + and Right * (Diagram A) or use a single 4 W speaker. For other amplifiers, please follow the speaker output connection diagram for bridging shown on rear: two 8 W speakers in parallel for a 4 W load or a single 4 W speaker per channel.

For any further enquiries, contact your local authorized Pioneer dealer or customer service.

Section

03

to 8 W for stereo connection, or 4 W to 8 W for

English

 

monaural and other bridge connection.

 

Subwoofer

 

 

 

Speaker channel Power

 

 

 

 

 

Nominal input:

Two-channel output Min. 135 W (GM-5400T)

Min. 60 W (GM-3400T)

Nominal input:

One-channel output Min. 420 W (GM-5400T)

Min. 180 W (GM-3400T)

Other than subwoofer

Speaker channel

Power

 

 

MAX input:

Two-channel output Min. 250 W (GM-5400T)

Min. 120 W (GM-3400T)

MAX input:

One-channel output Min. 760 W (GM-5400T)

Min. 350 W (GM-3400T)

Connecting the speakers

The speaker output mode can be two-channel (stereo) or one-channel (mono). Connect the speaker leads to suit the mode according to the figures shown below.

Two-channel output (Stereo)

About suitable specification of speaker

Ensure speakers conform to the following standards, otherwise there is a risk of fire, smoke or damage. Speaker impedance is 2 W

En

7