Installation
Note:
•Before making a final installation of the unit, tem- porarily connect the wiring to confirm that the con- nections are correct and the system works proper- ly.
•Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions.
•Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle.
•Install the unit where it does not get in the driver’s way and cannot injure the passenger if there is a sudden stop, like an emergency stop.
•The semiconductor laser will be damaged if it overheats, so don’t install the unit anywhere hot
— for instance, near a heater outlet.
Removing the Unit (Fig. 5) (Fig. 6)
•If installation angle exceeds 60° from horizontal, the unit might not give its optimum performance. (Fig. 3)
60°
Fig. 3
Frame
To remove the frame, extend top and bottom of the frame outwards in order to unlock it. (When reattaching the frame, point the side with a groove downwards and attach it.)
•It becomes easy to remove the frame if the front panel is released.
Fig. 5
DIN Front/Rear-mount
This unit can be properly installed either from “Front” (conventional DIN
DIN Front-mount
Installation with the rubber bush (Fig. 4)
Insert the supplied extraction keys into the unit, as shown in the figure, until they click into place. Keeping the keys pressed against the sides of the unit, pull the unit out.
Dashboard
182
53
Holder
After inserting the holder into the dash- board, then select the appropriate tabs according to the thickness of the dash- board material and bend them.
(Install as firmly as possible using the top and bottom tabs. To secure, bend the tabs 90 degrees.)
Rubber bush
Screw
Fig. 6
Fig. 4
