QUICK LINKS
Contents
Index
Regulatory Compliance
Product Information
Warranty
GETTING STARTED
About the Battery System
Locate Battery Housing
Identify Connector Ports
Install Battery Fuses
USING THE BATTERY
Charge Battery
Set Up Power Management
MAINTAINING THE BATTERY
Replace Battery
Troubleshooting
APPENDIXES
Battery Disposal
Specifications

24

Invitium Battery System BAT-24CM
Regulatory Information
U.S. Federal Communications Compliance Statement
The Planar Invitium Battery (model BAT-24CM) have has been tested and found to comply
within the limits of a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in
a particular installation.
If this equipment does cause harmful interference to radio or television reception (which can
be determined by turning the equipment on and off), the user is encouraged to try to correct
the interference by using one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and the receiver.
•Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technical for help.
Canadian DOC Notice
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital
apparatus as set out in the Radio Interference Regulation of the Canadian Department of
Communications.
“Le present appareil numerique n’emet pas de bruits radioelecinques depassant les limires
applicables aux appareils numeriques de la class B prescrites dans le Reglement sure le
brouiliage radioelectrique edicte par le minstere des Communications du Canada.”

Caution

To comply with the limits for an
FCC Class B computing device,
always use the cords supplied with
the unit. The FCC warns that changes
or modification of the unit not
expressly approved by the party
responsible for compliance could
void the user’s authority to operate
the equipment.
–MORE–