Planar C3 To change the conguration to single desktop

QUICK LINKS

Contents

Index

Regulatory Compliance

Product Information

Warranty

GETTING STARTED

About the Display

Package Contents

Identify Components

Position Display

Desk Stand Features

INSTALLING THE DISPLAY

Set DIP Switch

Install Display Controller

Connect Video and Power

Install Display Driver

Change Display Properties

Dome CXtra Software

APPENDIXES

Troubleshooting

Specifications

LED Status Lights

Single Desktop

USB Connection

Component Removal

Power Management

Palette Options 22

Dome C3 Display

To change the conﬁguration to single desktop

If you are working on a dual-headed display, you can use the following procedure

to change your hardware and software configuration to single desktop.

1Use the InstallShield Wizard to uninstall the existing driver (dx.5.1.0.003

release and higher). See “To uninstall the driver” on page 25.

2On the DIP switch, place switch 3 in the ON position. (See page 7.)

3Reinstall the DX display controller. (See page 8.) Then attach both displays to

the controller. (See page 9.)

4Power on the system, and run Setup.exe to install the driver. (See page 10.)

5Set the display resolution. (See page 11).

On the Dome tab, select

the single desktop

resolution 3072 x 2048 for

Safety precaution

Wear an antistatic wrist strap when

handling the board and display to

prevent electrostatic discharge.

Contents

Main Dome www.planar.com C3 Display DX/PCI Display Controller Reference Guide ii Contents iv Regulatory Compliance v vi European Union Declaration of Conformity for Medical Application vii FCC Compliance Statement viii Product Information To prevent re or injury Safety precautions Intended use To set up the display properly To disconnect the power supply properly To clean the LCD screen Symbol explanations Shipping/storing the display About the Dome C3 Display Package Contents Unpacking and handling tips Identify the Components Review this illustration of the back panel to identify controls and ports on the display unit. Controls and connector ports Position the Display Tilt range Height range Viewing angle Orientation mode Swivel the display panel from side to side to adjust the viewing angle. Desk Stand Features Stand lock Stand cover release USB hub Set the DIP Switch Warning Install the Display Controller To install the display controller Connect Video Cable and Power Supply To connect the display Installation tips Install the Display Driver To install the driver To enable the display Change the Display Properties To determine screen assignments To set the resolution To set palette options To set brightness To set driver options To get information Enhancements with Dome CXtra Software Troubleshooting Page Display Specications Power Supply Reliability Environment Video Modes Resolutions expressed in pixels (W x H). Single desktop requires dual displays. DVI 1.0 Interface DIN connector Details of the 8-pin DIN connector. LED Status Lights Power-up sequence information from LED LED A status information after initial power-on LED B status information after initial power-on Single Desktop To set the display resolution To change the conguration to single desktop To get information Restoring dual heads USB Connection To use the USB ports Display Driver and Controller Removal To uninstall the driver To remove the device Power Management Palette Options Palette options with multiple displays Desktop icons Dynamic gray palette Nonlinear static gray palette Static gray palette Index Page Overview of Standard Warranty Summary Standard Warranty Return Procedure 1 Summary Limitations and Exclusions of Dome Displays 1 2 3 4 Limitation of Implied Warranties Exclusion of Damages 1 2 3 Effect of Local Law