Planar LA1710RTC, LA1710RTR manual Connecting the display Figure

Connecting the display (Figure 1.1)

To set up this display, please refer to the following figure and procedures.

1.Be sure all equipment is off.

2.Connect the DC power cord to the power connector. Plug one end of the AC power cord into the power adapter, and the other end into an electrical outlet(1).

3.For the PC with Analog graphics output: connect the VGA signal cable from display VGA input connector to the 15-pin connector of your host computer and tighten the screws(2).

4.For DVI-D output: connect DVI cable from display to the PC(2a).

5.For the LA1710RTR or the LA1710RTC touch screen models configure the touch screen. Refer to the “Touch Screen Driver Installation” section on page 25.

6.Turn on your computer, display and video source.

Notice: To ensure the LCD display works well with your computer, configure the display mode of your graphic card, less than or equal to 1280

x 1024 resolution and make sure the timing of the display mode is compatible with the LCD panel. “Video Modes” of this LCD panel are listed in the appendices for your reference.

LA1710R, LA1710RTR and LA1710RTC User’s Guide (020-0320-02 Rev. A) 11