11
Connecting the Display (Figure 12.1) To setup this display, please refer to the foll owing figur e and procedur es.
1. Be sure all equipment is turned off.
2. Connect the AC power cord to the power connector on the monitor and
the other end into an electrical outlet (12.1).
3. Connect the D-SUB cable from the display’s VGA input connector to the
D-SUB connector of your host computer and tighten the screws (12.1).
4. Connect the Audio-In cable from the audio input port of your display to
the Audio-out port of your computer (12.1).
5. Connect the RS-232 or USB cable from the RS-232 or USB port of your
display to the RS-232 port or USB port (12.1) of your computer.
6. Configure the touch screen. Refer to the “Touch Screen Driver
Installation” section on page 25.
7. Once the touch screen is configured, the monitor is ready for use.
Instructions to attach the magnetic stripe reader to the computer
(PT1550MX model)
1. Attach the USB Type A to A cable to the magnetic stripe reader.
2. Route the cable through the cable management opening in the desk
stand with the other monitor cables.
3. Plug the cable into the computer.
4. No driver is necessary.
To ensure the LCD display works well with your computer, please
configure the display mode of your graphics card to make it less than or
equal to 1024 x768 resolution and make sure the timing of the display
mode is compatible with the LCD display.
We have listed the compatible “Video Modes” of your LCD display in the
appendix for your reference.