Planar PX1910M manual Connecting the Display Figure

Connecting the Display (Figure 8.1)

To setup this display, please refer to the following figure and procedures.

1.Be sure all equipments are off.

2.Connect the DC power cord to the power connector; plug one end of the AC power cord into the power adapter, and then the other end into an electrical outlet(u).

3.Connect the VGA signal cable from display VGA input connector to the 15-pin connector of your host computer and tighten the screws(v).

4.For the PC with DVI digital output: Connect the DVI signal cable to the connector of the display card in your computer; connect the other side to the DVI-D input port of your display. Tighten the screws(w).

5.Turn on your computer and display.

Note: To ensure the LCD display can work well with your computer, please configure the display mode of your graphic card to make it less than or equal to 1280 x 1024 resolution and make sure timing of the display mode is compatible with the LCD display. We have listed the “Compatibility Modes” of this LCD display in appendices for your reference.

English 7