Manuals / Brands / Computer Equipment / Network Router / Planet Technology / Computer Equipment / Network Router

Planet Technology ADW-4401 A/B 2. Installation, 2.1 System Requirement, 2.2 Hardware Installation, Step 1. Connect the ADSL Line, Step 2. Connect a Workstation to the Router's LAN port

1 42

Download 42 pages, 863.58 Kb

2. Installation

This chapter offers information about installing your router. If you are not familiar with the hardware or software parameters presented here, please consult your service provider for the values needed.

2.1 System Requirement

1.Personal computer (PC)

2.Pentium II 233 MHz processor minimum

3.32 MB RAM minimum

4.20 MB of free disk space minimum

2.2 Hardware Installation

This section describes how to connect and configure the ADW-4401.

Power	To PC /	To ADSL
Adapter	Hub	Line

Step 1. Connect the ADSL Line

Connect the router directly to the wall jack using the included ADSL cable.

Step 2. Connect a Workstation to the Router's LAN port

There are two methods to connect the router and workstation. The one use the crossover Ethernet cable to connect directly between them. The other use straight Ethernet cable to connect router with hub (or switch), then go to the workstation.

Contents

Page Copyright Federal Communication Commission Interference Statement FCC Caution: Federal Communication Commission (FCC) Radiation Exposure Statement R&TTE Compliance Statement WEEE Regulation Safety Revision Page Page 1. Introduction 1.1 Feature Fixed or Dynamic IP Address Advanced Internet Functions Virtual Servers Firewall Universal Plug and Play (UPnP) 1.2Package Contents 1.3 Physical Details WLAN LAN Rear Panel Rear panel Port and Button Definition Connector 2. Installation 2.1 System Requirement 2.2 Hardware Installation Step 3. Connect the Power Adapter to the Router Step 4. Connect All Cables to the Network 3 Configuration 3.1 Determine your connection settings 3.2 Connecting the ADSL Router to your network 3.3 Configuring with Web Browser 3.3.1 Quick Setup Guide Quick Start RUN WIZARD Next Page 3.3.2 System Time 3.3.3 Admin Setting 3.3.4 Firmware Update 3.3.5 System Log 3.3.6 System Reset 3.4.1 ADSL Status 3.4.2 ADSL Statistics 3.4.3 VC Configuration 3.5.1 WAN Configuration 3.5.2 WAN Status 3.5.3 DNS 3.5.4 DDNS 3.6.1 LAN Configuration 3.7.1 Wireless Settings 3.7.2 Wireless Security 3.8.1 IP Filtering 3.9.1 NAT Setting 3.9.2 Virtual Server 3.9.3 DMZ Setting 3.9.4 ADSL Type Setting 3.10.1 Static Routing 3.10.2 Dynamic Routing 3.10.3 Routing Table 3.11.1 System Status Appendix A: Glossary CPE DHCP (Dynamic Host Configuration Protocol) DMT Downstream rate DSLAM FTP Hop count HTML HTML browser http IP address ISP MAC MIB NAT Remote server RFC Route Router Routing Table Spanning-TreeBridge Protocol (STP) Spoofing Static IP Address Subnet TCP Telnet Transparent bridging UDP UNI signaling Virtual Connection (VC)