When choosing a location, please keep in mind the

 

environmental restrictions discussed in Chapter 1,

Note

Section 4, Specification.

 

 

Step 4: Connect your Switch to network devices.

A. Connect one end of a standard network cable to the 10/100 RJ-45 ports on the front of the FNSW-4800 Switch.

B. Connect the other end of the cable to the network devices such as printer servers, workstations or routers…etc.

 

Connection to the Switch requires UTP Category 5

 

network cabling with RJ-45 tips. For more information,

Note

please see the Cabling Specification in Appendix A.

 

 

Step 5: Supply power to the Switch.

A. Connect one end of the power cable to the Switch.

B. Connect the power plug of the power cable to a standard wall outlet then power on the Switch.

When the Switch receives power, the Power LED should remain solid Green.

2.3.2 Rack Mounting

To install the Switch in a 19-inch standard rack, follow the instructions described below.

Step 1: Place your Switch on a hard flat surface, with the front panel positioned towards your front side.

Step 2: Attach a rack-mount bracket to each side of the Switch with supplied screws attached to the package. Figure 2-3 shows how to attach brackets to one side of the Switch.

10