4. TROUBLESHOOTING
This chapter contains information to help you solve problems. If Giga Switch is not functioning properly, make sure the Ethernet Switch was set up according to instructions in this manual.
Some stations cannot talk to other stations located on the other port
Solution:
The address table may contain older information than of the address table of that node. Please power down to refresh the address information.
Performance is bad
Solution:
Check the full duplex status of the Ethernet Switch. If the Ethernet Switch is set to full duplex and the partner is set to half duplex, then the performance will be poor.
Why the Switch doesn't connect to the network
Solution:
Check the LNK/ACT LED on the Switch Try another port on the Switch I
Make sure the cable is installed properly Make sure the cable is the right type
Turn off the power. After a while, turn on power again