3.Be noticed, there are 2 ways for RJ45 cable connector avoiding water or thunder stoke.

a.Stick and bind with rubber mastic tape on RJ45 cable connector after connecting cable to “P+DATA OUT” port of PoE Injector.

b.After connecting cable to “P+DATA OUT” port of PoE Injector, open the Back Cover and put the RJ45 cable connector inside of Back Cover, then plug the Back Cover to CPE Set for preventing water.

4.Using Category 3 or higher UTP or STP cable, connect the “DATA IN” port of PoE Injector to a 10Mbps or 10/100Mbps Ethernet hub or switch, and connect the PC on the same LAN for management.

To avoid thunder strike, consider to install ELA-100, thunder arrester toward the CPE AP and the PoE injector.

Note

5.Connect the power cord to the PoE Injector, and plug it into an AC outlet to power on the WAP-6200.

1.ONLY use the power adapter supplied with the WAP-6200. Otherwise, the product may be damaged.

2.Strongly suggest using SFTP cable whether the cable exposed

Note outdoor for waterproof and avoiding thunder stroke.