3.2 Configuration

In this screen, you can configure the wireless settings of WL-8317. After configuration, please press ”Apply” to save settings or “Cancel” to set again.

‹SSID: The SSID must be identical for each clients and nodes in the wireless network.

‹Wireless Mode: Click pull-down button and select the work mode below.

¾Ad-Hoc:This mode indicates the peer-to-peer operation. All communication is done from client to client without the use of an Access Point.

¾Infrastructure: This operation mode requires the presence of an Access Point. All communication is done via the Access Point.

‹Ad-Hoc Band: There are three options available for selection

¾11B: Allows user to set the 802.11b standard wireless network.

¾11G: Allows user to set the 802.11g standard wireless network.

‹Channel: Shows the number of the radio channel used for the networking.

‹Tx Rate (11B/G): Shows the Data Transfer Rate. If Auto Mode is selected, the device will choose the best transfer rate automatically.

‹Power Mode: Shows Power Management modes. There are two optional selections for this mode.

¾Continuous Access Mode: WL-8317 will always set in active mode.

¾Maximum Power Save: WL-8317 will enter power saving mode when it is idle.

¾Power Save: WL-8317 consumes the moderate level of power.

‹Preamble: There are two options can be selected: Short & Long Preamble, Long Preamble. Preamble is a sequence of bits transmitted at 1Mbps that allows the PHY

9