To USE, Washing Instructions | Playskool 23393 specification

TO USE

NOTE: This product is shipped in "demo" mode. Open seam on back and slide switch to "play" for full use at home.

Your child’s BEDTIME WISHES GLOWORM friend eases the transition to bedtime with a friendly, glowing face and special wish that rhymes. All it takes is a gentle squeeze to bring this lovable character to life.

WASHING INSTRUCTIONS

(DO NOT WASH TOY WITH ELECTRONIC UNIT INSIDE!)

Open back, untie laces and remove electronic unit. Place the toy in pillow case and tie end closed. Machine wash in cold water, gentle cycle, mild detergent, NO BLEACH. Tumble dry in pillow case on low heat setting. After the toy is dry, distribute filling evenly throughout body. (During washing, filling may bunch up.) Place electronic unit in the toy with the bulb toward the head and the activation bar facing tummy. Fit lace through tab on each side of unit and tie to other lace. Close seam.

TO REPLACE LIGHT BULB

PR-3 or PR-7 (max 1.2W) bulb required. (Light bulb should be replaced by an adult.)

1.Open seam on back. Untie laces and remove electronic unit.

2.Loosen and remove screws from lens cover. Remove lens cover, and pull out and discard old bulb.

3.Insert a PR-3 or PR-7 (max 1.2W) light bulb into bulb compartment. Place lens cover back on electronic unit and retighten screws. Test to be sure unit works by pressing activation bar.

4.Place electronic unit in the toy with the bulb toward the head and the activation bar facing tummy. Fit lace through tab on each side of unit and tie to other lace. Close seam.

PLAY

DEMO

Ties

	P
DEMO	Y
	LA