User’s Manual
Operation
8
Operation Turn On/Off Procedure
A. Power on
Press the Standby/On key to turn on the lamp. The LED will blink green during warm up
and then light solid green.
"INPUT SIGNAL DETECTED, ACTIVATING AUTO IMAGE" will be displayed on the
screen after the projector has identified the input signal;
“SEARCHING“ message will be displayed on the screen if there is no signal input;
“SYNC IS OUT OF RANGE” message will be displayed on the screen if the horizontal
frequency of the input signal exceeds the range of the projector.
B. Standby
Press the Standby/On key, the following messages will be displayed to make sure you really want to
power off the unit:
■ Are you sure to power off?
■ Press “Power” again to power off.
The LED will then blink orange and the lamp will shut down, but the fan will continue to run for about
1 minute to cool the lamp. After the fan stops, the LED will turn to a light solid orange.
*Lamp Protection Procedure: If you try to turn on the lamp again while the LED is blinking, the projector
will ignore the command until it cools down for one minute.
External Control
A. Control Pad
Hotkey
Menu Auto
-Keystone
+Keystone Stanby/On
Indicator
Stanby/On
LampStatus
Indicator
Remote
Receiver
Figure 12 Hotkey control pad
3