E – 44
Troubleshooting
Check the following matters before requesting servicing.
*Has the power plug become disconnected from the outlet?
*Is the lamp cover properly attached?
*Has the internal temperature become high? When the internal temperature becomes
very high, to protect the unit the power will not switch on.
*Has the lamp timer exceeded 1,100 hours? The power will no longer switch on once
the timer has exceeded 1,100 hours.
*Has the connected input been selected?
*Is the cable of the input connector properly connected?
*Are the Picture 1 brightness and contrast adjustments (incorrectly) set to a mini-
mum?
*Has the lamp burned out?
*If the projector is connected to a personal computer, is a signal being output from the
personal computer?
*Has a signal been input that does not correspond to the supported frequencies of the
projector?
*Is the STATUS indicator flashing?
*Is the projector installed properly?
*Is the keystone adjustment properly adjusted?
*Is the lens properly focussed?
*Are the projection screen and the projector installed at the proper angle?
*Has the projection distance exceeded the focussing range?
* Is there condensation on the lens and other parts?
When the projector has been stored in a cold location and the power is switched on in
a warm location, there may be condensation on the lens and other internal optical
parts. Should this occur, wait several minutes until the condensation disappears.
*Is the input signal being supported for resolution and frequency? Check the resolu-
tion of your personal computer.
*At the time of RGB input, is the clock frequency correct or shifted a little?
*At the time of YPbPr input, does the format setting match the input signal or is it
different?
*When the image is broken in the horizontal or vertical direction, or the image does not
fill the entire screen, select a suitable aspect ratio.
*When a YPbPr signal is input, does the color space setting match the input signal or
is it different?
*At the time of VIDEO or S-VIDEO input, is the tint adjustment correct or is it shifted a
little?
*The phase of the input signal might be shifted.
*Is an obstacle located between the remote control and the remote control sensor of
the main unit?
*Is the remote control out of range for its signal to reach the sensor?
*Is there strong light or a fluorescent lamp in the vicinity of the sensor?
*Are the batteries weak? Try directing the remote control toward the remote control
sensor from a close distance and operating it. If there is difficulty in changing settings,
the batteries are weak. Replace the batteries with new ones.
*There might be a fault with the projector.
*Has the LED been set to off?
Problem
No power
(POWER/ indicator does not
light)
No video
Distorted video
Blurred video
Image position is shifted and
doesn't display properly
Image is broken
The color of the whole image is
strange
Characters flicker or color is
not correct with RGB or YPbPr
input
Remote control does not func-
tion
STATUS indicator lights or
flashes
POWER/ indicator is off while
projecting
Check Reference Page
E-16
E-46
E-45
E-43, 46
E-23, 26
E-17 – 19
E-33
E-45, 46
E-20
E-49
E-45
E-22
E-39
E-22
E-22
E-13
–
E-43
E-35
E-38
E-23, 27
E-38
E-34
E-35
E-11
E-11
–
E-11
E-45
E-40