Press twice

Contents

1.How to Put Your Heart Rate Monitor On

179335 USA/GBR D

Heart Rate Monitor

User Manual

USA/GBR

1.How to Put Your Heart Rate Monitor On

2.Functions and Modes of Polar A5

3.How to Start and Stop

4.Functions During Exercise

5.After Exercising

6.How to Recall File Stored in Memory

7.Settings

8.Target Heart Rate Zone

9.Self Walk Test by Polar and UKK Institute

10.Resetting

11.Minimizing Possible Risks in Exercising with Heart Rate Monitor

12.Technical Specifications

13.Limited Polar International Guarantee

14.Disclaimer

The Polar A5™ wrist receiver

displays your heart rate during exercise.

The transmitter

detects your heart rate continuously and transmits it to the wrist receiver.

The elastic strap

holds the transmitter in the correct position.

Keep the wrist receiver within 3 feet/ 1 meter of your transmitter. Check that you are not near other people with heart rate monitors or any source of electromagnetic disturbance.

1. Attach the transmitter to the elastic strap.

3.Lift the transmitter off your chest and

moisten the two grooved electrode areas on the back.

2.Adjust the strap length to fit snugly and comfortably. Secure the strap around your chest, just below the chest muscles, and buckle it.

4.Check that the wet electrode areas are firmly against your skin and the Polar logo is in a central, upright position.

2.Functions and Modes of Polar A5

How to operate the set buttons

Time of day display Press Up FILE

3.How to Start and Stop

How to Set up Your New Polar A5 Receiver

How to Start

Reset

If reset, settings will return to the default values.

Up

Moves to the following mode or increases the selected value.

To move forward or back, use Up or Down button.

To choose the value to begin adjusting, press OK. It will begin blinking.

Press Up or Down button to adjust the value (The digits run faster if you press and hold the button).

Wherever you are in the settings, you can return to the Time of day display by pressing and holding OK.

Time of day display mode

Press OK

 

Press Up

 

 

Heart rate measuring

 

 

 

SETTING

 

 

 

 

 

 

 

 

 

 

Press Up

 

 

 

 

 

 

 

 

 

Press OK

WALK TEST

Exercise recording

File mode

1. Press any of the four buttons twice to activate

the receiver. Unit is displayed. LBS/INCH is

flashing.

2. Once awakened, the receiver will guide you

through the necessary settings.

Scroll up or down to set the right values.

Press OK to lock your selection.

Set the following:

Measuring units – lbs/inch or kg/cm

12h or 24h time mode

Time of day

Date

1. In the Time of day display press OK. Your heart rate appears in a few seconds.

2.Press OK again. The stopwatch starts running and you can start exercising. The exercise data will only be stored if you have turned the stopwatch on.

Signal/Light

Alarm on or off.

Backlight on.

OK

Starts measuring heart rate. Starts and stops the stopwatch. Enters the displayed mode. Locks in your selection.

Down

Returns to the previous mode or decreases the selected value.

Heart Touch function

Bring the wrist receiver up to the Polar logo on the transmitter during exercise and you can check the time of day.

Starting point for all functions

Shows date and time

Press and hold OK to return to the Time of day display, wherever you are in the Settings or File recalling cycle.

When the alarm is turned on, the symbol appears on the Time of day display. When the alarm comes on it will sound for one minute or you can turn it off by pressing any of the four buttons.

Exercise recording mode

In the Exercise mode you measure your heart rate and record your exercise information in a file

You can view different information while the heart rate monitor is measuring heart rate

• Shows the data recorded during the exercise

Setting mode

Set different values

-unit measurement; weight, height, time

-user data

-target heart rate limits

-watch functions; alarm, time, date

Walk Test mode

Based on 1.24 miles/2 km brisk walk

Measures cardiorespiratory fitness

Weight

Height

Sex

Birthday

After setting your birthday, your target heart rate zone based on your age is automatically calculated.

After the settings are complete, the receiver automatically goes to the Time of day display.

You can cancel the setting by pressing and holding OK, but you can not start measuring the heart rate before you have completed the settings.

How to Stop

1. Press OK to stop the stopwatch. QUIT and paused stopwatch appear. Measurement is paused. Pressonce Exercise is no longer recorded.

2.Press Up or Down button to exit the Exercise mode.

The receiver shows the Time of day display within 5 minutes if you forget to quit the heart rate measurement mode when you stopped the stopwatch and removed the transmitter from your chest.

4.Functions During Exercise

1.Press Signal/Light to turn the light on.

2.Press and hold Signal/Light to turn the zone alarm sound on or off.

3.Check the time of day by bringing the wrist receiver up to the Polar logo on the transmitter.

4.Scroll up to select what values you want to view in the upper row of the display during exercise.

1. Heart rate in the target zone is displayed

a) as absolute heart rate or

b) as a % of maximum heart rate

according to your lower row selection.

2. Fitness bullets

For every 10 minutes in TZ, a appears.

3. Calorie expenditure

The calorie calculation starts when your heart rate reaches 100 bpm.

5.Scroll down to select what you want to view in the lower row of the display.

1. Heart rate in beats per minute.

2. Heart rate as a % of your maximum heart rate.

3. Exercise time

4. Time of day

6.You can pause the stopwatch by pressing OK. Repressing OK will restart the stopwatch.

After restart you will see heart rate in the lower row.

5.After Exercising

1.Carefully wash the transmitter with a mild soap and water solution.

2.Rinse it with pure water.

3.Dry the transmitter carefully with a soft towel.

4.Keep the wrist receiver clean and wipe off any moisture.

5.Store the heart rate monitor in a clean and dry place. Dirt impairs the elasticity and functioning of the transmitter. Sweat and moisture can keep the electrodes wet and the transmitter activated, which shortens battery life.

The combined impact of moisture and intense

abrasion may cause a black color, which might stain light-colored clothes especially, to come off the transmitter's surface.

6.How to Recall File Stored in Memory

Time of day

 

Press Up

FILE

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

display

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Press OK

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

EXE. TIME

 

Press Up

AVERAGE HR

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1. While in the Time of

 

 

 

 

 

 

Press Up

IN ZONE

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Press Up KCAL

 

 

day display mode press

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Up or Down until FILE is displayed.

 

 

 

 

 

 

 

 

Press Up BMI

 

 

2. Press OK.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

3. Scroll up or down to recall the exercise

 

 

 

 

 

Press Up W INDEX

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

information:

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

EXE. TIME Total exercise time

 

 

 

 

 

 

 

 

 

 

 

 

 

 

AVERAGE HR Average heart rate of the exercise

 

 

 

 

 

 

IN ZONE Time spent in target zone

 

 

 

 

 

 

 

 

 

 

 

 

 

 

KCAL Calories expended during the exercise

 

 

 

 

 

 

BMI

Interpretation

 

BMI Body mass index

 

 

 

 

 

 

 

 

 

 

 

 

 

 

< 18.5

Underweight

 

W INDEX WalkIndex, the result of the walking test

 

 

 

18.5 - 24.9

Normal weight

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

25.0 - 29.9

Overweight

 

The most convenient way to determine whether a

 

 

 

30.0

Obesity

 

 

 

 

 

 

 

person is overweight is to use the Body Mass Index,

Reference: World Health Organization. Obesity: preventing and managing the

BMI. The body mass index does not describe the

 

 

 

global epidemic. Report of a WHO Consultation on Obesity. Geneva: World

amount of fat tissue but merely serves as a means for

Health Organization, 1998.

 

 

 

 

 

 

 

 

comparing adult persons in terms of overweight or

The BMI value does not distinguish between muscular

underweight.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

and fat tissue. Thus, a weight-lifter may have a BMI

value which indicates obesity although the person only has large muscles and little fat tissue.

Page 1
Image 1
Polar a5 user manual Contents