INSTALLATION, OPERATION AND MAINTENANCE MANUAL
POLARIS - SERIES TBM 200 LH ( 8” ) - TYPE PHO / PBO / PVO
11of 29
DOCUMENT NBR. : PED-010 REVISION: 1 EFFECTIVE
DATE: 08-24-2004
5.0 ELECTRICAL INSTALLATION
5.1 GENERAL
Power supply and electrical work must be as per local and national codes. All wiring
and installation of cables, relays, disconnects, etc., should be performed by qualified
personnel. Check that main line voltage and frequency agree with the specifications
on the motor data plate. Prior to installation of any wiring, inspect both main power
and control cable for possible cuts and tears.
5.2 MOISTURE SENSOR RELAY
Failure to install / operate the specified Motor Moisture-Detection Relay and
not connecting the thermal over-load wiring will void your Warranty.
POLARIS PUMPS requires the use of a Warrick Controls - Type 2810 moisture
detection relay. This relay must be purchased with your pump as an integral part of
the package to validate your warranty.
See Section 8.3 for dimensional information and wiring diagram.
5.3 INSTALLATION
All activities related to the electrical installation, maintenance and operation and
service of the motor module must be in accordance with the
RELIANCE ELECTRIC
Application, Installation & Operation Manual
Duty Master Submersible Motors
See Section 8.2 of this pump manual.