Polycom KH 458 manual Interface Implementation, Set the Switch Interface Type

2

Interface Implementation

This section describes the recommended programming to use the

Wireless Telephone System with an Inter-Tel Eclipse PBX with an

Associate Display Phone. The procedures assume:

•The Eclipse system is installed and operational in an approved configuration. See the Telephone Switch Interface Matrix document for tested configurations.

•A trained Inter-Tel technician or system administrator will be on site with the SpectraLink installer to program the system.

•The SpectraLink 6000 System or SpectraLink 8000 Telephony Gateway is installed and the handsets are available for programming.

The Inter-Tel Eclipse digital interface to the SpectraLink 6000

System is licensed for use in the U.S. and Canada only

Set the Switch Interface Type

SpectraLink 6100 MCU

The Link 150 Master Control Unit requires the switch interface type to be configured using the front panel buttons. The configuration procedures are detailed in the SpectraLink 6100 MCU: Installation and Operation document.

SpectraLink 6300 MCU

When configuring the SpectraLink 6300 MCU, the PBX interfaces are available as sub-menu selections when defining the Interface Module type using the SpectraLink 6300 MCU Operator’s Console. Refer to SpectraLink 6300 MCU: Operator’s Console for details on configuring the Interface Modules.

PN: 1725-36136-001_E.doc 13