14.Maintain a firm grip on the saw and position your body and arm in a way that allows you to resist KICKBACK forces. KICKBACK forces can be controlled by the operator, if proper precautions are taken.
15.When blade is binding, or when interrupting a cut for any reason, release the trigger and hold the saw motionless in the material until the blade comes to a complete stop. Never attempt to remove the saw from the work or pull the saw backward while the blade is in motion or KICKBACK may occur. Investigate and take corrective actions to eliminate the cause of blade binding.
16.When restarting a saw in the workpiece, center the saw blade in the kerf and check that teeth are not engaged into the material. If saw blade is binding, it may walk up or KICKBACK from the workpiece as the saw is restarted.
17.Support large panels to minimize the risk of blade pinching and KICKBACK. Large panels tend to sag under their own weight. Supports must be placed under the panel on both sides, near the line of cut and near the edge of the panel.
18.Do not use dull or damaged blade. Unsharpened or improperly set blades produce narrow kerf causing excessive friction, blade binding, and KICKBACK.
19.Blade depth and bevel adjusting locking levers must be tight and secure before making cut. If blade adjustment shifts while cutting, it will cause binding and KICKBACK.
20.Use extra caution when making a “Pocket Cut” into existing walls or other blind areas. The protruding blade may cut objects that can cause
KICKBACK.
21.Some wood contains preservatives which can be toxic. Take extra care to prevent inhalation and skin contact when working with these materials. Request, and follow, all safety information available from your material supplier.
22.
WARNING: There are certain applications for which this tool was designed.
Technical Service Manager
4825 Highway 45 North
Jackson, TN 38305
| SAVE THESE INSTRUCTIONS. |
SYMBOL | DEFINITION |
V | ........................ volts |
A | ........................ amperes |
Hz | ........................ hertz |
W | ........................ watts |
kW | ........................ kilowatts |
µF | ........................ microfarads |
l | ........................ liters |
kg | ........................ kilograms |
N/cm2 | ........................ newtons per square centimeter |
Pa | ........................ pascals |
h | ........................ hours |
min | ........................ minutes |
s | ........................ seconds |
| ........................ alternating current |
5
