Porter-Cable 363, 362VS, 360VS, 361 instruction manual Selecting AN Abrasive Belt

SELECTING AN ABRASIVE BELT

The principle abrasive materials used on belts for machine sanding are aluminum oxide and silicon carbide. Aluminum oxide is the softer of the two, but is tougher and more suited for woods and soft (non-ferrous) metals. Silicon carbide is extremely hard and is best suited for surfacing stone, marble, and glass.

Abrasives are classed as open-coated (with grits spaced apart), or closed- coated (with grits close together). Closed coatings provide hard, fast cutting action for hardwoods and dense metals, while open coatings are more suited to soft materials and painted surfaces.

To obtain the best finish, start with a “COARSE” grade of abrasive and change to “MEDIUM” and then to“FINE” as work progresses.

GENERAL SANDING

SECURE THE WORKPIECE and maintain a FIRM GRIP on the sander. Movement of the sanding belt against the workpiece will try to move the work backward and/or the sander forward.

Verify that the switch is “OFF” before connecting the sander to the power circuit.

1.Hold the sander off the work before starting the motor.

2.Lower the sander to the work, touching the rear part of the belt first. Level the machine when moving it forward.

3.Guide the machine over the work in overlapping strokes. Allow the sander to do the work.

4.Avoid applying excessive pressure. The weight of the machine is usually sufficient for a fast smooth finish. A slight increase in pressure may speed removal of material, but too much pressure will slow the motor and decrease removal.

5.Work back and forth over a fairly wide area to obtain an even surface.

6.Do not let the tool tilt. The edge of the belt can make a deep cuts into the surface.

7.Do not pause in any one spot during the sanding operation. The belt will eat into the work and make the surface uneven.

8.Lift the tool from the work before turning the motor off.

9.Always be sure that the motor has completely stopped before putting the tool down.

FAST SANDING ON ROUGH WORK

To smooth a rough surface quickly, use a coarse grit abrasive belt. With the belt positioned diagonally across the grain, move the tool in the direction of the grain (Fig. 5).

Overlap the strokes and cover the entire surface, working from both sides of the board (angle left and then angle right.) Smooth the surface by guiding the sander back and forth with the grain. Change the belt to a medium grit and follow the same procedure.

Finish by thoroughly working the grain lengthwise. Change again to a fine grit and repeat. Always finish sanding with the grain.

Fig. 5

12