Porter-Cable 4115, 4113, 4114 HALF-BLIND Dovetails, Preparing Router, Clamping Drawer Parts

1/2" HALF-BLIND DOVETAILS

The following are required to produce 1/2" half-blind dovetails.

	#1	Edge Guide (furnished with Model 4112)
	4113	1/2" Half-Blind Dovetail Templet (furnished with Model 4112)
	42046	5/8" Templet Guide (furnished with Model 4112)
Available	42237	Locknut (furnished with Model 4112)
as
Accessories
	43705	Carbide Tipped, 1/2" Dovetail Bit (1/4" Shank)
	or
	43750	Carbide Tipped, 1/2" Dovetail Bit (1/2" Shank)

Fig. 3

PREPARING ROUTER

1. DISCONNECT ROUTER FROM POWER SOURCE.

2.Insert templet guide, (A) Fig. 4, in hole (B), in router sub-base (C).

3.Install templet guide locknut (D) on templet guide and firmly tighten to lock templet guide in sub-base.

4.Insert dovetail bit, (A) Fig. 5, through templet guide into router collet.

5.Adjust router so dovetail bit projection (B) from bottom of router sub-base (C), is 9/16".

Fig. 4 Fig. 5

CLAMPING DRAWER PARTS

1.Temporarily clamp the left side of the drawer “inside out” under front clamp bar and extending approximately 1/4" above top surface of the base as shown in Fig. 6.

Fig. 6 Fig. 7

6