PROBLEM

CAUSE

CORRECTION

 

Pressure reading

It is normal for “some”

If there is an excessive amount

 

on the regulated

pressure drop to occur.

of pressure drop when the

 

pressure gauge

 

accessory is used, adjust the

 

 

regulator as instructed in the

 

(if equipped)

 

 

 

Operation section.

 

drops when an

 

 

 

NOTE: Adjust the regulated

 

accessory is

 

 

 

pressure under flow conditions

 

used.

 

 

 

(while accessory is being

 

 

 

 

 

 

used).

 

 

 

 

 

Air leak from

Possible defect in safety

Operate safety valve manually

 

safety valve.

valve.

by pulling on ring. If valve still

 

 

 

leaks, it should be replaced.

 

 

 

 

 

Compressor is

Prolonged excessive use of

Decrease amount of air usage.

 

not supplying

air.

Check the accessory air

 

enough air to

Compressor is not large

 

operate

enough for air requirement.

requirement. If it is higher than

 

accessories.

 

the SCFM or pressure supplied

 

 

 

by your air compressor, you

 

 

 

need a larger compressor.

 

 

Hole in hose.

Check and replace if required.

 

 

Check valve restricted.

Remove and clean, or replace.

 

 

Air leaks.

Tighten fittings.

 

 

Restricted air intake filter

Clean or replace air intake

 

 

 

filter. Do not operate the air

 

 

 

compressor with the filter

 

 

 

removed. Refer to the “Air

 

 

 

Filter” paragraph in the

 

 

 

“Maintenance “ section.

 

 

 

 

 

Restricted air

Dirty air filter.

Clean or replace. See Air Filter

 

intake

 

paragraph in the Maintenance

 

 

 

section.

 

 

 

 

 

Regulator knob

Damaged regulator

Replace

 

has continuous

 

 

 

air leak.

 

 

 

 

 

 

 

Regulator will

Damaged regulator

Replace

 

not shut off air

 

 

 

outlet.

 

 

 

 

 

 

21- ENG

A02231

Page 21
Image 21
Porter-Cable CPLDC2540P instruction manual Pressure reading