SAFETY FIRST!
WARNINGS
DO’S AND DO NOTS
WARNING: FAILURE TO COMPLY WITH THESE WARNINGS AND OPERATING
INSTRUCTIONS COULD RESULT IN DEATH OR SERIOUS BODILY INJURY.
DO NOT DO NOT DO NOT DO NOT DO NOT DO NOT DO NOT DO NOT DO NOT DO NOT DO NOT DO NOT DO NOT DO NOT DO NOT DO NOT
DO NOT DO NOT DO NOT DO NOT
DO NOT DO NOT DO NOT DO NOT DO NOT DO NOT DO NOT DO NOT DO NOT DO NOT DO NOT
DO NOT
operate this machine unless you have read and understood this operator’s manual. operate this machine without the blade guard, or other protective guards in place. stand behind or in front of the blade path while the motor is running.
leave this machine unattended while the motor is running. work on this machine while the motor is running. operate this machine when you are tired or fatigued.
use a wet blade without adequate water supply to the blade.
exceed maximum blade speed shown for each blade size. Excessive speed could result in blade breakage. operate the machine if you are uncertain of how to run the machine.
use damaged equipment or blades.
touch or try to stop a moving blade with your hand. cock, jam, wedge or twist the blade in a cut.
use a blade that has been dropped or damaged. use carbide tipped blades.
use abrasive blades.
touch a dry cutting diamond blade immediately after use. These blades require several minutes to cool after each cut.
use damaged or worn blade flanges.
allow other persons to be near the machine when starting or when the machine is in operation. operate this machine in an enclosed area unless it is properly vented.
operate this machine in the vicinity of anything that is flammable. Sparks could cause a fire or an explosion.
allow blade exposure from the guard to be more than 180 degrees. operate this machine with the blade guard removed.
operate this machine unless you are specifically trained to do so. use a blade that has been over heated (Core has a bluish color). jam material into the blade.
grind on the side of the blade.
lay power cords in or near the water.
replace the motor with any motor that does not have a special grounding connection. stand or lean on machine.
start cutting with a saw until you have a clear work area and secure footing. operate this machine while using drugs or alcohol.
****************
This saw was designed for certain applications only. DO NOT modify this saw or use for any application other than for which it was designed. If you have any questions relative to its application, DO NOT use the saw until you have written Electrolux Construction Products and we have advised you.
Electrolux Construction Products
17400 West 119th Street
Olathe, Kansas 66061
9
