Porter-Cable LR1100 General Maintenance, Keep Tool Clean, Failure to Operate, Battery

-Reorient or relocate the receiving antenna

-Increase the separation between the equipment and receiver

-Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and

(2)This device must accept any interference received, including interference that may cause undesired operation.

IMPORTANT: Changes or modifications to this product not authorized by Porter-Cable Corporation, could void the FCC Certification and negate your right to operate the product.

Porter-Cable Corporation

4825 Highway 45 North Jackson, TN 38305

Copyright © 2002, All rights reserved.

GENERAL MAINTENANCE

KEEP TOOL CLEAN

All plastic parts should be cleaned with a soft damp cloth. NEVER use solvents to clean plastic parts. They could very possibly dissolve or otherwise damage the material.

FAILURE TO OPERATE

Should your laser square fail to operate, make sure batteries are charged and properly installed.

BATTERY

The batteries will discharge if stored for long periods of time, and may require replacement before use.

SERVICE AND REPAIRS

All quality tools will eventually require servicing or replacement of parts due to wear from normal use. These operations, should ONLY be performed by either an AUTHORIZED PORTER-CABLE SERVICE STATION or a PORTER- CABLE • DELTA FACTORY SERVICE CENTER. All repairs made by these agencies are fully guaranteed against defective material and workmanship. We cannot guarantee repairs made or attempted by anyone other than these agencies.

Should you have any questions about your laser square, feel free to write us at any time. In any communications, please give all information shown on the nameplate of your laser square (model number, type, serial number, etc.).

11