Porter-Cable Model 543 Functional Description, Motor, Extension Cord Selection, Foreword

MOTOR

Many Porter-Cable tools will operate on either D.C., or single phase 25 to 60 cycle A.C. current and voltage within plus or minus 5 percent of that shown on the specification plate on the tool. Several models, however, are designed for A.C. current only. Refer to the specification plate on your tool for proper voltage and current rating.

Do not operate your tool on a current on which the voltage is not within correct limits. Do not operate tools rated A.C. only on D.C. current. To do so may seriously damage the tool.

EXTENSION CORD SELECTION

If an extension cord is used, make sure the conductor size is large enough to prevent excessive voltage drop which will cause loss of power and possible motor damage. A table of recommended extension cord sizes will be found in this section. This table is based on limiting line voltage drop to 5 volts (10 volts for 230 volts) at 150% of rated amperes.

If an extension cord is to be used outdoors, it must be marked with the suffix W- A or W following the cord type designation. For example – SJTW-A to indicate it is acceptable for outdoor use.

RECOMMENDED EXTENSION CORD SIZES FOR USE WITH PORTABLE ELECTRIC TOOLS

					Length of Cord in Feet
		115V	25 Ft.	50 Ft.	100 Ft.	150 Ft.		200 Ft.	250 Ft.	300 Ft.	400 Ft.	500 Ft.
		230V	50 Ft.	100 Ft.	200 Ft.	300 Ft.		400 Ft.	500 Ft.	600 Ft.	800 Ft.	1000 Ft.
		0-2	18	18	18	16		16	14	14	12	12
	Rating	2-3	18	18	16	14		14	12	12	10	10
		4-5	18	18	14	12		12	10	10	8	8
		3-4	18	18	16	14		12	12	10	10	8
	Ampere
		5-6	18	16	14	12		10	10	8	8	6
		6-8	18	16	12	10		10	8	6	6	6
	Nameplate	8-10	18	14	12	10		8	8	6	6	4
		10-12	16	14	10	8		8	6	6	4	4
		12-14	16	12	10	8		6	6	6	4	2
		14-16	16	12	10	8		6	6	4	4	2
		16-18	14	12	8	8		6	4	4	2	2
		18-20	14	12	8	6		6	4	4	2	2
				SAVE THESE INSTRUCTIONS!
				CARTON CONTENTS
* Bayonet saw							* Anti-splinter base insert
* Blade							* Carrying case

* Non-marring base

FUNCTIONAL DESCRIPTION

FOREWORD

Model 543 Bayonet Saw is designed for cutting materials of the following MAXIMUM thickness: wood 41/3", plastic and fiberglass 11/4", aluminum and nonferrous metals 13/16", mild steel 3/8", and stainless steel 1/8". The saw is also equipped with the Keyless Quik-Change™ Blade Clamp for ease of blade

installation and removal.

8