90550129 PC1800D 4/1/09 2:38 PM Page 10
LED WORK LIGHT
When drill is activated by pulling the trigger switch (1), the integrated LED work light (9) will automatically illuminate the work area.
ADJUSTING TORQUE CONTROL - FIGURE F This tool is fitted with a torque adjustment collar (3) to select the operating mode and to F set the torque for tightening screws. Large screws and hard workpiece materials require a higher torque setting than small screws and soft workpiece materials.
•For drilling in wood, metal and plastics,
set the collar to the drilling position symbol 
•For screwdriving, set the collar to the desired setting. If you do not yet know the appropriate setting, proceed as follows:
| 4 |
| 1 |
3 | 12 |
| |
| 10 |
| 8 |
•Set the collar to the lowest torque setting.
•Tighten the first screw.
•If the clutch ratchets before the desired
result is achieved, increase the collar setting and continue tightening the screw. Repeat until you reach the correct setting. Use this setting for the remaining screws.
DUAL RANGE GEARING - FIGURE G
The dual range feature of your drill allows you to shift gears for greater versatility. To select low speed, high torque setting (position 1), turn tool off and permit to stop. Slide gear shifter button (4) away from the chuck. To select the high speed, low torque setting (position 2), turn tool off and permit to stop. Slide gear shifter button back (towards the chuck).
NOTE: Do not change gears when tool is running. If you are having trouble changing gears, make sure that the dual range gear button is either completely pushed forward or completely pushed back.
KEYLESS CHUCK - FIGURE H
To insert a drill bit or other accessory:
1.Grasp the chuck (5) and rotate it in the counterclockwise direction, as viewed from the chuck end.
2.Insert the bit or other accessory fully into the chuck, and tighten securely by rotating the chuck in the clockwise direction as viewed from the chuck end.
: Do not attempt to tighten drill bits (or any other accessory) by gripping the front part of the chuck and turning the tool on. Damage to the chuck and personal injury may occur when changing accessories.
G |
4 |
14 |
12 |
0 |
1 |
8 |
H |
| 14 |
5 | 12 |
| |
| 0 |
| 1 |
| 8 |
10
