Porter-Cable PCK3030SP, D27927-034-0 Nozzle Cleaning, How To Clean The Water Inlet Filter

Models: D27927-034-0 PCK3030SP

1 20
Download 20 pages 997 b
Page 16
Image 16
NOZZLE CLEANING

NOZZLE CLEANING

If the nozzle becomes clogged with foreign materials, such as dirt, excessive pressure may develop. If the nozzle becomes partially clogged or restricted, the pump pressure will pulsate. Clean the nozzle immediately using the nozzle kit supplied and the following instructions:

1.Shut off the pressure washer and turn off the water supply.

2.Disconnect spark plug wire.

3.Pull trigger on gun handle to relieve any water pressure.

4.Disconnect the spray wand from the gun.

5.Remove the high-pressure nozzle from the spray wand. Remove any obstructions with the nozzle cleaning tool provided and backflush with clean water.

6.Direct water supply into spray wand to backflush loosened particles for 30 seconds.

7.Reassemble the nozzle to the wand.

8.Reconnect spray wand to gun and turn on water supply.

9.Start pressure washer and place spray wand into high pressure setting to test.

HOW TO CLEAN THE WATER INLET FILTER

This screen filter should be checked periodically and cleaned if necessary.

1.Remove filter by grasping end and removing it from water inlet of pump as shown.

2.Clean filter by flushing it with water on both sides.

3.Re-insert filter into water inlet of pump. NOTE: Cone side faces out.

NOTE: Do not operate pressure washer without filter properly installed.

Filter Screen

D27927

16- ENG

Page 16
Image 16
Porter-Cable PCK3030SP, D27927-034-0 instruction manual Nozzle Cleaning, How To Clean The Water Inlet Filter