| SPECIFICATIONS |
Free Speed (No Load) | 1800 RPM Max. |
Maximum Working Pressure | 90 PSI |
Air Inlet | 1/4" NPT |
Recommended Hose Size | 3/8" I.D. |
Keyless Chuck | 3/8” |
Air Consumption @ 90 PSI | 4.5 SCFM |
|
|
| ASSEMBLY |
|
|
Accessories Required
IMPORTANT: Line pressure or hose inside diameter should be increased to compensate for unusually long air hoses (over 25 feet). Minimum hose diameter should be 3/8” I.D. and fittings should have 1/4” NPT thread.
OPERATION
Before each use:
●Drain water from air compressor tank
and condensation from air lines. See | Trigger | |||||
air compressor’s operators manual. | ||||||
| ||||||
|
|
|
| Disconnect the tool |
| |
|
|
|
|
| ||
|
|
|
|
| ||
|
|
|
| from the air supply |
| |
|
|
|
|
| ||
before lubricating or changing drill | Chuck | |||||
bits. | ||||||
●Lubricate tool, see “Maintenance” section in this manual.
●Open the keyless chuck (A), no tools
| are required. | Reverse | Air |
| Insert and center drill bit in the jaws | ||
● | and | Inlet | |
| |||
| (B) as you close chuck. NOTE: An off | Forward |
|
| centered drill bit will wobble and could | Knob |
|
break.
●Connect tool to air hose of recommended size. NOTE: The use of a quick connect set makes connecting easier.
IMPORTANT: The use of air filters and air line lubricators is recommended.
To use:
●
●
Turn air compressor on and allow air tank to fill.
Set the air compressor’s regulator to 90 PSI. This tool operates at a maximum 90 PSI pressure.
●Place the tool in reverse or forward position. Push knob in and turn clockwise for reverse. Push knob in and turn counter clockwise for forward.
Forward
Reverse
5- ENG | D22723 |
