be supplied through the interface cable from the main unit and just connect the video interface cable. Connect the other end of VGA cable to the appropriate VGA port. The monitor will always turn ON whenever power is made available.
Power Connector in VGA for
VGA Connector | Power Connector from Power |
5.Adjust for best viewing tilt angle and engage the on screen display (OSD) adjustment for best display effect whenever necessary. The monitor will sign for “No Signal” status and go into power saving mode in 5 seconds when there is no video signal. The display will come back when the signal does.
V.OSD
A.OSD buttons
“OSD” button: To enter OSD setup menu, or to perform function selected in OSD operation.
“NXT” button: To go to next option function. “”
“” button: To increase setting.
“” “” button: To decrease setting.
“” “” button: To turn the monitor power ON/OFF. The monitor can be turned OFF only when there is video signal and can be turned ON only when there is video signal and after the “Turn Off Panel” message vanishes. The default status is set to ON when power is supplied unless manually turned OFF. Since this button controls only the display power but not the display controller, please try disconnect the power cable or the VGA cable once unfortunately the screen display goes into a mess.
Part 3
