“VARI-SPEED” ADJUSTMENT

Over time, the drive control system may become “loose”, resulting in decreased speed. There is a thumbscrew on the underside of the drive control housing to increase tension on the drive cable. Pro- ceed as follows:

Turn unit off and disconnect spark plug wire from spark plug.

Rotate thumbscrew counter-clockwise to tighten the drive cable.

Operate mower to test drive speed.

If condition fails to improve after the above steps (forward speed remains the same), your drive belt is worn and

should be replaced.

NOTE: If mower begins to "creep" forward, the drive cable is too tight. Rotate thumb- screw clockwise to loosen drive cable.

BEFORE STARTING ENGINE

Read the engine manual packed with your mower.

FILL ENGINE WITH OIL

Your lawn mower is shipped without oil in the engine.

Be sure mower is level and area around oil fill is clean.

Remove engine oil filler plug (oil fill cap/ dipstick on models so equipped).

Slowly add oil. For type and grade of oil to use, see “ENGINE” in the Mainte- nance section of this manual.

Fill to the top of slot in filler hole (to “FULL” line on dipstick on models so equipped). Do not overfill.

Replace plug (oil fill cap/dipstick on models so equipped) and tighten.

Check oil level before each use. Add oil as needed.

To change oil, see Maintenance section of this manual.

FILL GASOLINE TANK

Fill gasoline tank with fresh, clean, un- leaded gasoline. DO NOT USE PRE-

MIUM GASOLINE. BE CAREFUL NOT TO OVERFILL TANK.

WARNING: Experience indicates that alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the fuel tank, start the engine and let it run until fuel lines and

carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in fuel tank or permanent damage may occur.

TO START ENGINE

CAUTION: The mower blade rotates whenever the engine is running.

Move engine speed control to FAST position (or to CHOKE/START position on models equipped with choke feature).

If your mower has a primer, to start a cold engine, push primer as many times as instructed in the engine manual packed with your mower. Use a firm push. This step is not usually necessary when starting an engine which has already run for a few minutes.

Hold operator presence control bar down against handle.

MODELS WITH RECOIL STARTER

Pull starter handle quickly. Do not allow starter rope to snap back.

MODELS WITH ELECTRIC STARTER

Push the engine start button (or turn the key on models so equipped).

IMPORTANT: Do not crank engine more than five continous seconds between each time you try to start. Wait 5 to 10 seconds between each attempt.

ALL MODELS

For engines equipped with choke, slowly move engine speed control lever to FAST after engine starts.

TO STOP ENGINE

To STOP engine, release operator pres- ence control bar.

NOTE: For engines with a primer, it may be necessary to repeat priming steps

in cooler weather. In warmer weather, overpriming may cause flooding and engine will not start. If you do flood engine, wait a few minutes before attempting to start and DO NOT repeat priming steps.

Operator

Recoil

presence

starter

control bar

handle

 

(center

 

mount

 

type)

Recoil

starter handle (side mount type)

16

Page 16
Image 16
Poulan 172787 manual Before Starting Engine, To Start Engine, To Stop Engine, Fill Engine with OIL, Fill Gasoline Tank