OPERATION
•Remove retainer spring and clevis pin which secure each gauge wheel bar.
•Lower gauge wheels to ground. Raise gauge wheels slightly to align holes in bracket and gauge wheel bar and insert clevis pin. Gauge wheels should be slightly off the ground.
•Replace retainer spring into clevis pin.
IMPORTANT: BE SURE TO READJUST GAUGE WHEELS IF YOU CHANGE THE CUTTING HEIGHT OF THE MOWER DECK.
RETAINER |
SPRING |
CLEVIS |
PIN |
FIG. 10
TO OPERATE MOWER (See Fig. 11)
Your tractor is equipped with an operator presence sensing switch. Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged will shut off the engine.
•Select desired height of cut.
•Lower mower with attachment lift control.
•Start mower blades by engaging attachment clutch control.
•TO STOP MOWER BLADES - disengage attachment clutch control.
CAUTION: Do not operate the mower without either the entire grass catcher, on mowers so equipped, or the deflector shield in place.
•If slowing is necessary, move throttle control lever to slower position.
•If stopping is absolutely necessary, push clutch/brake pedal quickly to brake position and engage parking brake.
•Move gearshift lever to 1st gear and range shift lever to low (L) position. Be sure you have allowed room for tractor to roll slightly as you restart movement.
•To restart movement, slowly release parking brake and clutch/brake pedal.
•Make all turns slowly.
TO TRANSPORT
•Raise attachment lift to highest position with attachment lift control.
•When pushing or towing your tractor, be sure gearshift lever is in neutral (N) position.
•Do not push or tow tractor at more than five (5) MPH.
NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).
TOWING CARTS AND OTHER ATTACHMENTS
Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your tractor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.
BEFORE STARTING THE ENGINE
CHECK ENGINE OIL LEVEL
• The engine in your tractor has been shipped, from the |
factory, already filled with summer weight oil. |
• Check engine oil with tractor on level ground. |
• Remove oil fill cap/dipstick and wipe clean, reinsert the |
dipstick and screw cap tight, wait for a few seconds, |
remove and read oil level. If necessary, add oil until |
“FULL” mark on dipstick is reached. Do not overfill. |
• For cold weather operation you should change oil for |
easier starting (See “OIL VISCOSITY CHART” in the |
ATTACHMENT CLUTCH SWITCH PULL OUT TO “ENGAGE” 
PUSH IN TO
“DISENGAGE”
LIFT LEVER
HIGHEST
POSITION
LOWEST
POSITION
DELECTOR
SHIELD
Customer Responsibilities section of this manual). |
• To change engine oil, see the Customer Responsibilities |
section in this manual. |
ADD GASOLINE
•Fill fuel tank. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.
IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW 32°F(0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP INSURE GOOD COLD WEATHER STARTING.
FIG. 11 | WARNING: Experience indicates that alcohol blended fuels | ||
TO OPERATE ON HILLS | (called gasohol or using ethanol or methanol) can attract | ||
moisture which leads to separation and formation of acids | |||
|
| ||
CAUTION: Do not drive up or down hills |
| during storage. Acidic gas can damage the fuel system of | |
| an engine while in storage. To avoid engine problems, the | ||
with slopes greater than 15° and do not |
| fuel system should be emptied before storage of 30 days or | |
drive across any slope. |
| longer. Drain the gas tank, start the engine and let it run until | |
|
| the fuel lines and carburetor are empty. Use fresh fuel next | |
• Choose the slowest speed before starting up or down | |||
season. See Storage Instructions for additional information. | |||
hills. | Never use engine or carburetor cleaner products in the fuel | ||
• Avoid stopping or changing speed on hills. | 14 tank or permanent damage may occur. | ||
