To Replace Headlight Bulb, Interlocks and Relays | Poulan 183044

SERVICE AND ADJUSTMENTS

TO REPLACE HEADLIGHT BULB

•Raise hood.

•Pull bulb holder out of the hole in the backside of the grill.

•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

•Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 29)

•Raise hood.

•Unsnap headlight wire connector.

•Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

•To replace, reverse above procedure.

HOOD

HEADLIGHT WIRE CONNECTOR

FIG. 29

ENGINE

TO ADJUST THROTTLE CONTROL CABLE (See Fig. 30)

The throttle control has been preset at the factory and adjustment should not be necessary. Check adjustment as described below before loosening cable. If adjustment is necessary, proceed as follows:

•With engine not running, move throttle control lever to fast position.

•Check that swivel is against stop. If it is not, loosen cable clamp screw and pull cable back until swivel is against stop. Tighten cable clamp screw securely.

STOP

SWIVEL	CLAMP
	SCREW

FIG. 30

24

Image 24

Poulan 183044 To Replace Headlight Bulb, Interlocks and Relays, To Replace Fuse, To Remove Hood and Grill Assembly See Fig

Contents

PR17542STB Safety Rules IV. ServiceGeneral Operation II. Slope Operation Table of Contents Product Specifications Customer Responsibilities Unassembled Hardware Steering WheelSeat Keys Slope Sheet Assembly Tools Required for AssemblyHOW to SET UP Your Tractor To Remove Tractor from Carton Install Seat See Fig To SET UP Your Mower for Mulching To Convert to Bagging or DischargingCheck Tire Pressure Check Deck Levelness Operation Know Your Tractor HOW to USE Your Tractor To Adjust Gauge Wheels See Fig To Operate Mower See FigTo Operate on Hills To Transport Before Starting the Engine Check Engine OIL LevelADD Gasoline To Start Engine See Fig Mulching Mowing Tips Maintenance Lubrication ChartGeneral Recommendations Before Each USE Tractor Engine Cleaning Engine OIL FilterMuffler Spark Plugs Service and Adjustments To Install Mower See FigTo Remove Mower See Fig To Level Mower Housing FRONT-TO-BACK Adjustment See Figs To Check and Adjust Brake See Fig To Replace Mower Blade Drive Belt See Fig Transaxle Gear Shift Lever Neutral Adjustment See Fig To Adjust Steering Wheel AlignmentTo Replace Motion Drive Belt See Fig Front Wheel TOE-IN/CAMBER To Start Engine with a Weak Battery See Fig Replacing Battery See Figs To Remove Hood and Grill Assembly See Fig To Adjust Throttle Control Cable See FigTo Replace Headlight Bulb Interlocks and Relays To Adjust Choke Control See Fig To Adjust Carburetor Storage OtherFuel System Engine OIL Troubleshooting Points Problem Cause Correction When operator leaves Schematic Tractor - Model Number PR17542STB, Product Number 954 56 Electrical KEY Part NO. NO. Description Chassis and Enclosures KEY Part Description Drive 72110614 Steering Assembly Adaptor Wheel Strg Seat Assembly Decals Wheels and Tires Engine Optional EquipmentSpark Arrester 170771 Control Th/ch Flag Mower Deck 131335 Mower Lift 159460 Wire Asm Inner/Sprg W/plunger LT Page Page Page Limited Warranty Policy Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAX Parts and Service